NeT Firewall 2.x Does Not Load Port Mapping on Startup

Home › Forums › Discussions › Support › NeT Firewall 2.x Does Not Load Port Mapping on Startup

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 15, 2008 at 4:49 pm #5175
    jpontius
    Participant

      I have enabled NeT Firewall to load on Windows startup. I have configured in the firewall, one port mapping. However, when Windows starts up, the port mapping is not functional. I have to run the MMC once before the port mappings are enabled. Once it has been run, I can close it and the port mapping persists, but it does not seem to enable the port mapping on boot up.

      Please help explain what I need to do in order for it to load the entire configuration, including port mappings, during Windows startup without having to login and run the console.

      Thank you.

      February 16, 2008 at 12:19 pm #6554
      Kon
      Participant

        Hi.

        Thank you for your report about port mapping. Please use the last version of NeT Firewall.

        February 18, 2008 at 1:45 am #6555
        jpontius
        Participant

          Does this mean that it was a known bug in version 2.x and that it is fixed in the new version (3.x)?

          February 20, 2008 at 10:00 am #6556
          Vadim Smirnov
          Keymaster

            2.x firewall service loaded only filters and adapter modes, new features like port mappings were not supported. It was fixed in 3.x

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.