- This topic has 6 replies, 2 voices, and was last updated 20 years, 8 months ago by
.
-
Posts
-
It’s not clear from the documentation what happens calling IOCTL_NDISRD_READ_PACKET when there are no packets in the queue. How do I check when I’ve read the last packet in the queue?
You should check the returned status, when there are no packets in the queue WinpkFilter driver returnes NDIS_STATUS_FAILURE.
I’ve done some tests, it seems that IoCallDriver returns STATUS_INVALID_PARAMETER when I try a IOCTL_NDISRD_READ_PACKET on an adapter without packets in queue. Is this correct?
I’m also receiving a STATUS_INVALID_PARAMETER when I try a IOCTL_NDISRD_FLUSH_QUEUE on an adapter with an empty queue. Is this correct?
NDIS_STATUS_FAILURE is the same as STATUS_UNSUCCESSFUL. Are you sure that you get STATUS_INVALID_PARAMETER?
@SerpentFly wrote:
NDIS_STATUS_FAILURE is the same as STATUS_UNSUCCESSFUL. Are you sure that you get STATUS_INVALID_PARAMETER?
Yes, pretty sure. I’m not at work, so I cannot post the exact code, but roughly is:
… initialize the irp structure …
status = IoCallDriver( devObj, irp );
if( status == STATUS_PENDING )
WaitForSingleObject( devObj, …);
else if ( status == STATUS_INVALID_PARAMETER ) {
DbgPrint(“Invalid parameter”);
}
…This code is called in a cycle: where there are packets in queue, the status is correct, but on the last cycle, where there are no more packets on queue, it prints “invalid parameter”. Sadly I’m not at work so I can’t give you the exact hex value, but if I remember correctly it’s 0xC000000D.
The same happens with IOCTL_NDISRD_FLUSH_QUEUE on an empty queue.
- You must be logged in to reply to this topic.